Am unsure of what you are asking. The harmonic balancer is a lifetime part of the engine and does not need replacement based on a time or mileage requirement.
Harmonic balancer is bad and will need to be replaced.
There is a bolt in the center of it, 5/8ths inch. Remove that, then the three 9/16ths bolts in a triangle pattern, which removes the pulley. Then, you will need a harmonic balancer puller, as they are pressed on.
Go to Autozone and tell them u need a harmonic balancer puller
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
The harmonic balancer does require a puller if that is what you are asking.The harmonic balancer does require a puller if that is what you are asking.
no it;s behind the harmonic balancer take off passenger right front tire and you can get at it. you will need a wheel puller to pull the harmonic balancer off
take off the serpentine belt and crank pulley and you will need a harmonic balancer pulley to get it off.
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
You need a balancer puller to remove it , It don't just slide off.
Behind the harmonic balancer. You will need to remove the right front tire, remove the access panel to the engine (through the wheel well), remove engine belt, remove harmonic balancer & pulley with a puller. Remove & replace crank sensor, align sensor with an alignment tool, replace balancer with an installer tool.. BE VERY careful with the balancer, the backside of it has a hall effect style blades. bending these blades will junk the balancer.
If the oil is leaking from the timing chain cover behind the Harmonic Balancer (main large double pulley the belts run on). After removing the belts you need to remove the Harmonic Balancer using a puller, not to damage it, and then replace the seal in the cover. Inspect the back side of the Harmonic Balancer. The seal only seals to the shoulder of the Harmonic Balancer not the back face. If the shoulder's surface is not smooth replace it or it will leak again. Apply some light grease on the seal and mating surface of the Harmonic Balancer and reinstall. Re-install the belts. If it is leaking around the edges of the cover the sealant may need replacing. Also check the condition of the sealant around the oil pan. Both would require removal/cleaning and re-sealing.
Yes