There should be an extra pully. This pully appears to not go to anything, however it's job is go keep the belt tight. I don't recall the wrench size, I think it's 16mm. Put the wrench on the pully's center nut and push or pull towards the center, this should move the pully enough to get the belt off.
The power steering unit and the alternator are both driven by the serpentine belt. Loosen the tensioner pulley and the serpentine belt will become loose. Put the new serpentine belt on and tighten the tensioner pulley.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
Away from the serpentine belt
The serpentine belt on a 2003 Toyota Rav4 can be loosened by turning the retaining bolt on the idler pulley. The belt can then be shifted inward to loosen.
If it
You can replace the air conditioner serpentine belt of your 1995 automobile by removing the old belt. Take the new belt and feed it around the components. Loosen the tensioner bolt. This will help the new belt to fit properly. Once the new belt design tighten the tensioner bolt.
Loosen the tensioner pulley. Slide the tensioner pulley to the right. The serpentine belt will come loose. Remove the serpentine belt. Reverse the process to install the new serpentine belt.
Loosen the tensioner pulley. The serpentine belt will become loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.
To loosen the tension on a serpentine belt on a 2005 Grand Caravan 3.8L, turn the nut of the belt tension pulley to loosen it. Adjust the belt, then tighten the tension pulley by turning the nut in the opposite direction.
Look around the belt floating roller. Place a ratchet in the square hole and torque the ratchet. The tensioner will release.
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
a pully underneath the alternator moves with an end wrench. turn the nut clockwise and the belt will loosen up