Top Answer

What your after is how far apart the studs are apart,? generally 100mm or 114.3mm(4.5inches) its simply just how spaced out the 'circle' that the studs sit on.

If the stud pattern is a 4 x 120 it means it has four studs (holes) on a 120mm PCD (pitch circle diameter, circle that the holes are equally spaced on). If you measure the greatest distance apart on a four or even numbered stud pattern this will give you the diameter. If measuring a 5 or odd number pattern you need to measure the distance from center of wheel to center of stud. This will give you radius then multiply by 2 to get the PCD (diameter).

Example Say you had 5 studs and the radius was 62.5mm, X 2 = 125mm. Then the stud pattern would be a 5 x 125.

🙏

0🤨

0😮

0😂

0Loading...

Measure from the center of one stud to the center of another stud furthest away.

Chocolate ;)

check lugnutpatterns.com

Remove a rocker cover and measure one.

The stud pattern for a 1994 Mazda E2000 Van is a 4 x 120. That means it has four studs (holes) on a 120mm PCD (pitch circle diameter, circle that the holes are equally spaced on). If you measure the greatest distance apart on a four or even numbered stud pattern this will give you the diameter. If measuring a 5 or odd number pattern you need to measure the distance from center of wheel to center of stud. This will give you radius then multiply by 2 to get the PCD (diameter).

4x100. the way you check is to measure the center of one stud diagonally to the center of another stud. if it is 100mm, then they are definitely 4x100.

Hold a piece of paper over the wheel studs . Mark the center of each stud on the paper. Then draw a line from one stud across to furthest stud. Do this for each stud. You should have 5 lines all of which intersect in the center of the pattern. Then take a compass , put the point of the compass in the center of the pattern where the lines cross each other, then open the compass till the pencil touches the center of each stud. Draw a circle with the compass. Then measure across the circle with a ruler. That measurement will be the bolt pattern. On a Taurus, it will be metric. On most other Fords with a 5 bolt pattern, the measurement is in inches usually 4 and 3/4"

1992 Mitsubish lancer wheel stud pattern?

The stud pattern (PCD) is 4x114.3 with +38 to +40 offset

will

3

early (gen 1) honda civicsmazda rx5 and thats about it, a very rare stud pattern

5x114.3

Yes, the mr2 mk3 wheels fit all years 2000 to 2007. They will not fit the mk2 model which has a 4 stud pattern rather than the mk3 5 stud pattern.

count the number of studs, then Measure it. the distance from the center of one stud to the center of the one across from it is your bolt circle.

Yes. Unless it killed him. That would make it difficult.

if it has the same stud pattern yes. hope this helpsYes, as long as they fit.

5x114

NO

5x114.4

114.3

4x110

Standard pulsar n16 alloy wheels are 14x6 with a 45+ offset with 4/114.3 stud pattern

If the stud spacing, and offset is the same, then it will fit. Measure them both. Too stick the wheels on, not to sniff!

all corvettes run a 5x120.7 bolt pattern 68-82 used a 7/16 stud Low offset 84-89 12mm stud Med offset 90-current 12mm stud High offset