Oldsmobile Cutlass
Ford Explorer XLT
Late Model 1979-New Ford Mustangs

How do you open a siezed hood latch on 1990 Olds Cutlass?

646566

Top Answer
User Avatar
Wiki User
2005-10-12 23:46:16
2005-10-12 23:46:16

Hello,I found the problem.I opened it with a crowbar,then I unseized the latch and plenty of penetrating fluid.Thank you

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the 71 cutlass has no cable pull on latch in the middle of grill or just below frt. bumper

User Avatar

what is a 1998 olds moblie cutlass value

User Avatar

where is the emc located on a 1988 olds cutlass?

User Avatar

The firing order for a 1990 Olds cutlass supreme 3.1litre is 1, 2, 3, 4, 5, 6. The number one cylinder is closest to the pulleys on the left as you face it.

User Avatar

Where is the water pump on a 1995 olds cutlass supreme?"

User Avatar

how do you drain s 1999 olds cutlass radiatoe

User Avatar

on the block towards the firewall........tuner1978

User Avatar

On my '95, you open the passenger door and look at the outward side of the dash. There is a panel there with the fuses under it. Cindy my 1990 cutlass fuse box is in the left side of the glove box

User Avatar

GM vehicles do not use inertia/reset switches.

User Avatar

i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?

User Avatar

if your latch just broke, use a vice grip. if the cable itself has snapped, it gets tricker. my 2nd cutlass's cable snapped. i had to lift and jerk the hood manually until it came loose.

User Avatar

under drivers side rocker panel before rear wheel

User Avatar

No they dont. Althou some of the sister cars (Buick Century, Olds Cutlass Ciera) did.

User Avatar

how do you replace a starter on a 1998 cutlass

User Avatar

The last rwd Olds Cutlass was the 1988 model.

User Avatar

I have a 1998 olds cutlass and it is leaking cooling and have a bad ticking sound what do you think I should do.

User Avatar

An exploded view of the heater controls for a 1989 Olds Cutlass can be found in the Cutlass service manual. The manual can be found at most auto parts.

User Avatar

The temperature sensor on a 93 Olds Cutlass Cierra 3.3 is located on the back of the engine. It is on the intake manifold.

User Avatar

I am trying to take the motor out of a 95' Olds cutlass supreme. The trans. is giving me problems. How many bolts hold it in.

User Avatar

There were a reported 3,912 Cutlass convertibles sold in 1992

User Avatar

How do you replace a axle on a 95 holds cutlass supreme

User Avatar

how do you change a thermostat on a olds cutlass supreme 1983

User Avatar

Need to know a few things about your olds. What type of Cutlass is it? Engine size? This will make for a better answer for you. Need to know a few things about your olds. What type of Cutlass is it? Engine size? This will make for a better answer for you.

User Avatar

84 and 85 cutlass's came with olds 307 small blocks. and others came with V-6's. now an olds 307 will slide right into a 72 cutlass (i have one also (: as long as the cutlass was a v-8 (olds 350 rocket and olds 455's were the v-8s that came in the 72's.) so yes the bolt pattern on the tranny and the engine mounts will all match up with the 307 if the 72.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.