answersLogoWhite

0


Best Answer

if your latch just broke, use a vice grip. if the cable itself has snapped, it gets tricker. my 2nd cutlass's cable snapped. i had to lift and jerk the hood manually until it came loose.

User Avatar

Wiki User

โˆ™ 2005-08-04 01:34:26
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How can you get the hood open on a 1990 Olds Cutlass Ciera if your hood cable broke?
Write your answer...
Submit
Related questions

Does the 1990 Oldsmobile cutlass Ciera have an ABS?

no it has dic brakes


Where are the fuses located for 1990 cutlass ciera?

GLove box


What is the weight of a 1990 cutlass ciera?

Around 3,000 lbs


Can doors from a 1990 Olds Cutlass Ciera sedan be used to replace the doors on a 1990 Olds Cutlass Ciera station wagon?

yes, most of the panels can be used from one to the other


How do you change the brake pads on a 1990 Oldsmobile cutlass ciera?

FRONT OR REAR ?


Do 1990 cutlass ciera have licenses plate lights?

i think it is on the trunk lid above the plate.


Where is the crankshaft sensor located on a 1990 Oldsmobile cutlass ciera 2.5 l?

if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...


Where is the ECM relay located on a 1990 Cutlass cierra?

I've got an 89 cutlass ciera and it is located behind glove box. open and pull out like 4 screws and there it is.


1990 olds ciera and you would like to know if it is front wheel drive?

The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.


What causes a 1990 cutlass ciera hesitate and sputter when gas pedal is depressed or crusing and symptoms stop when brake is applied?

A 1990 Cutlass Ciera might hesitate and sputter when the gas pedal is depressed because of water in the fuel or because of damaged or dirty fuel injectors. You might also have an issue with the wiring or the distributor.


Where is the fuel filter located on a 1990 Olds Cutlass Ciera?

under drivers side rocker panel before rear wheel


Does the 1990 Pontiac 6000 LE have airbags?

No they dont. Althou some of the sister cars (Buick Century, Olds Cutlass Ciera) did.


How difficult is it to replace the thermostat on a 1990 Cutlass Ciera with a 3300 engine?

It is quite easy to change the thermostat in your 1990 Cutlass. Remove the thermostat housing retaining bolts. Remove the thermostat from the housing. Reverse the process to install the new thermostat.


Where is the brake light switch located on a 1990 Cutlass Ciera?

The brake light switch is located on a bracket behind the brake pedal support.


How many lbs of R12 freon does a 1990 Oldsmobile Cutlass Ciera 6cyl AC system hold?

I believe it is around 3 1/2#.


1990 Oldsmobile Cutlass Ciera V6-3300 3.3L Air will not come on any suggestions?

Air conditioner? Blown fuse Low refrigerant


Why would the headlight switch keep burning out on a 1990 Cutlass Ciera?

would have 2 say a bad ground..U have the voltage,just not a ---- GOOD ground.


Where is the fuel pump relay located on a 1990 Oldsmobile Cutlass Ciera?

Its in the engine compartment of the vehicle on the right hand side of the vehicle (your left) by the charcoal canister.


How much Freon does an Olds Cutlass Ciera 1990 6cyl hold?

most cars use about two cans of r12 refrigerant but a qualified tech should be checking your a/c


What other gm calipers will interchange with 1990 celebrity?

Any other GM A-body should work (82-96 Buick Century, Olds Cutlass Ciera, Pontiac 6000)


Where is the computer located on a 1990 olds cutlass ciera?

Remove the RH lower dashboard sound insulator and the glove compartment. Look for a shiny metal box about the size of an old GM ECM.


Where is the cam sensor for a 1990 Oldsmobile cutlass ciera?

i have a 90 cutlass ciera with a v6 3300 and just replased that. it is called a combanation sensor. its the crankshaft and cam together located at the back of the harmonic balancer attached to the block. it has 2 bolts on the right side holding it to the block a one in the middle to hold the sensor in place and the sensor sits in it and faces the harmonic balancer on the back of the interrupter rings


Where can you get instructions and a diagram on how to change a heater core in a 1990 Oldsmobile Cutlass Ciera?

You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.


Does a 1990 Olds Cutlass Ciera SL have a shift solenoid and is it possible for it to go out or quit working?

I have read a common problem with the 90-93 Oldsmobile cutlass is that the ground on the shift silinoid can cause it to lose 3rd and 4th gear, I am trying to figure out where it is located. Please if you know email scott@moteladvertising.com


Why does only one brake come on on a 1990 cutlass and not the other just blinks third brake light out too checked fuses and bulbs?

My 1991 Olds Cutlass Ciera had that problem and it was corrected by replacing the turn signal switch. Troubleshooting with the factory service manual pinpointed the problem. Paul S