answersLogoWhite

0


Best Answer

They do seem to bind up over time! At the latch handle, under the dash on the driver's side, see if it can be moved far enough to get tools in. Hesitate to suggest vise-grips, because you may well break the plastic handle. The right-angle end of a small pry-bar is about right, if it is notched deeply enough.

After you get it open, you might see if you can spray lubricant into the cable, as well as lubricate the moving parts of the latch, underhood.

User Avatar

Wiki User

โˆ™ 2008-02-07 16:54:34
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you pop the hood of a 1991 jeep Cherokee Laredo hood latch cable will not open it?
Write your answer...
Submit
Related questions

How do you remove the trasmission oil pan in a 1991 Jeep Cherokee Laredo?

I need to know asap how to remove a trasmission oil pan on a 1991 jeep Cherokee Laredo? Thank you!


What type of oil should you use for a 1991 Jeep Cherokee Laredo?

I have a 1991 Jeep Cherokee Laredo, in the manual it tell you to use 10W30, and that's what I have been using, hope this helps.


Value of 1991 Jeep Grand Cherokee Laredo?

The value of a 1991 Jeep Grand Cherokee Laredo will depend on the condition of the vehicle. The vehicle in average condition with 100,000 miles is worth an estimated $914.00 dollars.


How much oil does a 1991 Jeep Cherokee Laredo take?

6 quarts.


Diagram on replacing a serpentine belt for a 1991 Jeep Cherokee Laredo?

The diagram for replacing a serpentine belt for the 1991 Jeep Cherokee Laredo is located on the front of the vehicle inside the engine compartment. You can also find this diagram in the Chilton's manual for this vehicle.


How do you reset the maintenance required light on a 1991 Jeep Cherokee Laredo?

Unplug or replace maint. timer


Why won't brake lights on 1991 Jeep Cherokee Laredo work?

try unscrewing the back light covers and replacing the lights


How do you fix the automatic choke on 1991 Cherokee Laredo?

Do you have a 4L 6 cyl.? if so, there is NO automatic choke. It is controled by computer and sensors.


What type of Transmission fluid does a straight six automatic 1991 Cherokee Laredo use?

The AW4 transmission uses Dextron II.


Why would a 1991 Jeep Cherokee Laredo suddenly lose power going up long grades?

Fuel Filter? Air Filter?


What is the value of a 1991 Jeep Cherokee Laredo?

kelly blue book it. it gives all different type of prices depending on what you want to do with it. kellybluebook.com


What is the spark plug gap for 1991 Jeep Cherokee Laredo?

considering the fact, that i recently just searched it up. the gapping is about .35hope that helps


Why would a 1991 jeep Cherokee Laredo vibrate at 55 mph?

first check the front end steering. idler arm is usually the culprit.


Where is the fuel filter located on a 1992 Jeep Cherokee Laredo?

On a 1991 Cherokee Laredo, it's on the underside of the car towards the rear of the car on the drivers side, almost parallel with the rear wheels. It is bolted to the underside of the car using a bracket with two screws which are probably rusted solid. Good luck.


What year Jeep Cherokee computer fits a 1991 Jeep Cherokee?

A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.


Does a 1991 Jeep Laredo transfer case fit in a 1995 Grand Cherokee Jeep?

Depending on what transfer case is used, most of the time, yes they will fit.


How to tighten a serpentine belt on a 1991 Jeep Grand Cherokee Laredo 4.0?

Loosen up the power steering pump and pull on pump till belt is tight.


Where can you get a copy of the master fuse box diagram for a 1991 Jeep Cherokee Laredo?

Chiltons Auto Manual for Jeep Cherokees has diagrams for each of the jeep fuse boxes


Where is the Crankshaft Position sensor located on a 1991 Jeep Cherokee Laredo?

paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor


Why does a 1991 jeep Cherokee Laredo turn over so many times before it starts?

try replacing the crankposition sensor my 89 did the same thing and that is what fixed it for me.


How do you repair the hood latch for the 1991 Mercedes 190E 2.6 the handle in the car that opens the hood does not work it does not pop the hood?

The hood is openned by a cable that links the handle in the car the hood latch. If the cable is broken or detached then the hood will not open. The cable has two parts, an outer covering and the actual cable that pulls on the hood latch when the inside handle is pulled, you need to check the inside handle to see if the cable is still attached to the handle, also you need to check the hood latch to see if that end is still attached to the hood latch. If either is disconnected the you will need to get appropriate hardware(nuts,bolts etc) to attach it back but if the cable is broken it has to be replaced complete. This you might or might not be able to do depending on you skill and proficiency with tools.


If there is not a radiator cap on a 1991 Jeep Cherokee Laredo where do you put the water?

in your coolent overflow tank then squeeze the upper radiator house to pump it through the rest of the radiator and to the engine.


Why does my 1991 jeep Cherokee Laredo turn over so many times before it starts?

i have an 89 and mine did the same thing try replacing the crank position sensor.


Will a flex plate for a 1990 Jeep Cherokee Laredo fit on a 1992 Jeep Cherokee Laredo?

It should fit but, the crank position sensor produces a signal by referring to the flex plate. In 1991 Jeep went to a Chrysler fuel injection system and the windows that the crank sensor reads are different. So in other words it should bolt up but then it will not start.


What are the ratings and certificates for Cherokee - 1991?

Cherokee - 1991 is rated/received certificates of: USA:G