first unhook battery then unbolt wires ontop of starter should be one big wire with one large brass nut and two small wires held by one small nut then safely jack vehicule and remove two long bolts holding starter up and snake it out dont loose the shime between starter and block youll need it install is reverse to put the shim in put long bolt through starter hole then round hole in shim then tred it a litte in then put other bolt in through slot in shim you might have to wiggle it a little make shure its in ps:hole in shim goes on passenger side tighten everything up!!!
The 1989 Chevrolet Blazer 4.3 liter engine starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
What about it?
it is located by the frame next to your front tire. You can put your truck on ramps to get under there and change your starter.
Down low on pass side. You need to get under the car to see it.
No it will not even bolt up. GM redesigned the transmission and its not even close to being the same as the 1989 trans.
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
drop tank take pump assembly out of tank,unplug wires and repeat in reverse for install
== ==
yes, 82-93 are the same besides grill design
how do you install new ignition switch on 1989 chevy G10 van?
I believe that the first digital cluster on a S-10 Blazer was in 1989.
1982 - 1994 (early year models).