uh.. hello.. think mcfly.. compress the piston all the way into the caliper with huge channel locks or C clamp or a tool made for it like in a break kit. you should not be doing breaks sir.
take panel off doesnt have no srews so be carerful not to brake preasure clips radio just clips doesnt have no cables in back of radio
type brake fluid for car?
Fuse and/or switch Switch located at upper end of brake pedal under dash
mine on my 97 is on the rear window deck.
Disk brakes on rear? My 96 aurora was simple The disk brake slave cylinder has to be screwed in after you get the caliper off. After that its just like any other disk brake pad replacement
Check, or even better replace, the wires.
find the master cylinder and the brake line take the brake line off let all the fluid drain out then take the old one all the way off and put thenew back on
2001 Oldsmobile Aurora brake light bulb lamp replacement procedure: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
brake light on when driving oldsmobile alero
Check the brake fluid.
You have to take the two bolts off of the arm then the whole rotor comes off its a size 18mm ned a half inch breaker bar and a pipe is helpful they are stubborn!!
They are burned out.