Spark Plugs and Wires
Mazda Trucks
Ford Ranger XLT
1995-2005 Chevy Cavaliers

How do you put the plug wires back on a 1994 Mazda B2300 truck?

474849

Top Answer
User Avatar
Wiki User
2005-12-05 15:27:28
2005-12-05 15:27:28

take em off 1by1 and put them back on after each one you take off

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Can you take a Ford Ranger 1994 bed and put it on a 1994 Mazda B2300? Truth be told, they are the same truck. My 1995 B2300 has "Made for Mazda by Ford" on a sticker inside the door of the driver's side. Also, the Chilton's manual for the Mazda B series trucks are the same as the one for the Ford Ranger.

User Avatar

If you have to ask such an obtuse question I suggest you just take to a local shop and have it done.

User Avatar

It is behind the Timing Cover. Torwards the crank pulley.

User Avatar

Polk Audio db571 or Infinity Reference 6822cf

User Avatar

i have a 1995 madza b2300 truck & i believe that the 94 and 95's are identical. i am trying to remove and replace the water pump. i have all 4 bolts removed but i can't get the water pump off the bracket. thanks

User Avatar

It maybe a leak in the intake manifold gasket.

User Avatar

how to replace power steering pump on 1994 Mazda b2300

User Avatar

use a c clamp to squeeze the piston closed

User Avatar

where i look only year 1994 mazda b4000 truck -fuel sending that find hard time

User Avatar

go to www.drivetrain.com and find your particular vehicle

User Avatar

To the best of my knowledge it will only work on a !996 or newer.

User Avatar

Rcommended manual transmission lubricant type: MERCON automatic transmission fluid - Haynes Repair Manual #36071, 1994-2005 Mazda Pick-ups B2300, B2500, B3000, B4000.

User Avatar

I need a diagram of the fuel tank on a 1994 Mazda B-2300 Truck

User Avatar

Kind of hard to explain and describe the process. Recommend you purchase Haynes Repair Manual #36071 (1993-2005 Ford Ranger Pickups/ 1994-2005 Mazda Pickups) or check at your local library to see if there is one available. You will find all the steps plus illustrations on how to perform the job.

User Avatar

Check the temp sensor on the thermostat goose neck. Mine got broken and when the truck warmed up it wouldn't start. Let it get cold and it would. about $25 at a parts store.

User Avatar

how do you remove the fan clutch on a 1994 mazda b 4000 4.0

User Avatar

The location of the turn signal flasher on a 1994 Mazda B2300 P/U is located on the fuse block under the dash. Most likely, yours is located there also.

User Avatar

Did you try disconnecting the positive battery terminal for a minute then reconnecting it? Soemtimes this will reset the computer and the light will go out.

User Avatar

The fuse for your 1994 Mazda pickup truck four-wheel-drive can be found in the fuse box. The four-wheel-drive fuse will be the number 14 fuse.

User Avatar

the starter is going to be under the truck on the driver side, in between the motor and transmission,

User Avatar

Hello, I just put new brakes on a '94 Mazda B2300. To change the front brakes pads, remove the caliper by taking hammer and punch to the upper and lower chrome triangle tabs and push them thought, then pull off your caliper. Now you can access your brake pads. Also remove your rotor you have inner and outer wheel bearings that need to be repacked and adjusted. You also have to have new wheel bearing seals, as they get torn up pulling them out to access the inner bearing. hope this helps.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.