it depends on which line is it the shifter line, or is it the lines that go to the trans coller? if it is then they should all have factory quick disconects that usually slip right in to place the two person didnt need to disconect them if you have more prpoblems contact the tow company and complain that they fudged up your car.
If it is the same as my Cherokee it will be on the top of the transmission on the driver side right behind where the engine and transmission join.
The crankshaft sensor on a 4.0L Jeep Grand Cherokee is mounted on the top driver side of the transmission bell housing.
It is a three wire switch on the driver side of the transmission.
You do not reattach any mechanism. You will have to replace the window regulator.jd
On the V8 it is on the passenger side top of the transmission bell housing, on the six cylinder it is on the driver side top of the transmission bell housing.
The crankshaft position sensor is on the top driver side of the transmission bell housing.
The orange and white wire on a 2004 Jeep Grand Cherokee near the driver's side door is probably a part of the seat belt sensor. If the driver is not wearing a seat belt when the car is driven, there is a chime that will sound. If this chime is not sounding, it was probably disconnected.
There are little medal horse shoe clips that must be removed before you can remove the lines. Use a small screew driver, there is 1 per line.
The crankshaft position sensor is on the top driver side of the transmission bell housing.
The Transmission Control Module (TCM) is located on the lower side of the transmission, behind the driver side axle. Look surfe.be/ext/2252908 surfe.be/2252908
instructions for how remplace driver side glass window in 92 cherokee?
Yes, it is on the driver side top of the transmission.Yes, it is on the driver side top of the transmission.