with engine off and in park of course , no power needed , reach up behind parking light and pull down on hinge about center of light until it releases from locked position kind of like an elbow if you will , then best to let the light close by itself with engine vacuum.
Yes, the headlights should be completely identical.
Remove 2 nuts that hold it in place and disconnect it form the headlight. It should pivot out of position.
go to http://www.supermotors.net/registry/media/611233
A Corvette that was built in late 1976 up to late 1977.
Most older GM headlight switches are removed by (diconnect battery) reaching under dash to the headlight switch and depressing the small release button at the top of the switch while pulling on the stem for the switch then unplug the wire harness. There is a stem nut behind the knob that fastens the assy to the dash surface.
what is the process for installing new seat covers in a 1977 chevrolet corvette
How do I replace the power window switch on 1977 Corvette coupe
Spark plug gap for a 1977 Corvette using ACDelco R45TS is .035
== == more than likely your dimmer switch is bad,hope that will help
You can find a diagram of a 1977 Corvette horn assembly at your local library. Look in the car repair section for a Corvette repair book.
No, the last year for the Corvette to be called a Stingray was in 1976.
Depends on the model of the vehicle. Older models have the switch on floorboard. Newer models have the switch on the steering column. Can not say unless you specify make and model. Corvette 1977
I think $8500
The fuse box in the 1977 corvette is on the outside wall under the dash on the drivers side - about as far up in the corner as they could put it.
The 1977 Corvette 350 LS has ignition timing standard in this model. The purpose of the ignition timing is to help start the car in synchrony.
The fuse box on a 1977 corvette is located at the top of the kick panel on the drivers side. It is just below the dash on the outside wall............7T77T7
A roadster is a convertible. The Stingray was the 1969-1977 Corvette model. The 1968 was the same body style, but was not called Stingray.
No the back spacing is wrong, c-4 to c-6 does not work, GRR
Horsepower is not a unit of mass.
Every Corvette since the first one has fuel injection. Corvette was the first fuel injected automobile in the US. Every Corvette since the first one has fuel injection. Corvette was the first fuel injected automobile in the US.