Want this question answered?
The Starter motor on a fuel injection Hyundai Pony/Excel is located below the inlet manifold coming from the injection system. It is difficult to access and the only way to get there is by removing the actual inlet manifold.
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
I can't say were because I'm yet to look but if you follow the positive terminal it should lead you there.
how to change starter on Hyundai scoupe 1993 12 valve
how do i remove the starter motor Mazda rx8
It can be found at the back of the engine about half way down the block, you will need to jack the car up to get to it, if you need to change it out. hope this helps.
Disconnect the cable from negative terminal of the batteryIf working on a 2.0L detach the shift cable from the transaxleDisconnect the speedometer cable from the transaxleUnscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoidRemove the start motor mounting bolts and remove the starter
how to remove starter motor on bmw 745
how to remove starter motor for Peugeot 206 1.4 hdi.
How do i remove an Audi A6 Starter motor
disconnect battery. from underneath disconnect solenoid wire and battery cable from starter solenoid. remove starter motor bolts. remove starter motor. installation is the reverse but be sure to place the starter shim between the starter motor and the engine or you will get noise during starts.