Want this question answered?
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
1: disconnect the drive shaft from the rear axle. 2: disconnect the front shaft from the transmission (tedious and you need the correct size tool). 3: disassemble the front shaft from the main shaft by pulling them apart from the center or in front of the support and drop the main shaft. 5: remove bolts holding the support and drop and remove the front shaft shaft with the support still connected. 6: remove and replace the support with a wheel puller. 7: replace support with new part. 8: reassemble in reverse. CDARCO
how to remove front bumper 2002 Impala
The front drive shaft did not have any grease zerks from the factory.
You will need to remove the plate on the housing to drain it. There's a fill plug on the front side where the drive shaft hooks to it.
2002 bravada oldsmobile
They run down the center of the engine under the coils. You can see the coils when you remove the resonator (the thing that says Vortec 4200 on it). One bolt holds the coils in place. Remove coils and change plugs. Actually you will need to remove the two front tire to to get to them and I would advise watching videos on the removal as two have struts blocking direct assess and you will need a flexible shaft extension or an universal joint for those two at least.
show location of camshaft position sensor for 2002 Oldsmobile bravada.
The front axle shaft will be cv style, so zero there.The front drive shaft would have three.The rear drive shaft would have two if it is a one piece shaft, three if a two piece shaft.The front axle shaft will be cv style, so zero there.The front drive shaft would have three.The rear drive shaft would have two if it is a one piece shaft, three if a two piece shaft.
Front wheel drive? Not applicable
I have a 2002 Oldsmobile bravada and we changed the oil today it took about 7-8 quarts.
how do you remove the rear struts/shocks on 2002 hyundai sonata.