0
The front bumper is pretty easy to take off, as long as the bolts arent rust fast. The first bolts to take out are the ones holding the bumper guards in place they are down under the fiberglass felance. Then unbolt the two side bolts, then unbolt the two center bolts.
RJ Sottilewww.hobbycarcorvettes.net
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove front seats on 1971 vw beatle?
How to remove front seats on 1971 vw Beatle
Will a 1971 cutlass front bumper fit on a 1970 cutlass?
Yes, but the signal lights are the wrong shape.
What is the maximum speed of Chevrolet Corvette 425 hp 1971?
The 1971 Chevrolet Corvette Stingray (425 HP) has a top speed of 202 km/h (126 mph).
What is the engine oil capacity for a 1971 corvette 350?
5
Could a 1971 Chevelle possibly have been built with the rear bumper?
all 71 chevelles had a rear bumper.
What year heads are 3873487?
1971 chev truck/corvette/lt1
Where can I view a diagram of a 1971 corvette wiper door assembly?
A 1971 Corvette wiper door assembly diagram at most Chevrolet dealerships. You can also view the diagram at most auto-parts stores.
How do you remove front kick panel in 1971 Chevelle?
take the chrome sill plate off and then you can pull out the kick panel from the bottom of it.
Where is high beam switch location on 1971 Corvette?
The 1971 Corvette High Beam headlight switch is located on the floorboard, actuated by the driver's left foot, like most cars of that period. However, Corvette hid it under the carpet, with a reinforced pad molded into the carpet over the switch location. Neat huh?
How do you release the latch to open the hood on a 1971 Lincoln Continental?
reach below the bumper there should be a lever there just above the front licence plate mount . pull it and the hood should pop open enough to get at the auxiliary latch in the middle front under the hood edge.
How do you remove the antenna from a 1971 Corvette?
my 71 corvette has a solid antena and i'm trying to take it off, inorder to align my car cover over the stem, cannot cut two holes on this cover need to be first go. I tried with pliers it chews into the stem base? Looking forward to a solution thx. James
How do you remove front kick panels with vent in 1971 Chevelle?
The door sill plates need to be removed, then the screws need to be removed. Then the panel should just wiggle loose.
