You need a special tool sold at most auto parts stores such as Autozone.
twist it counter clockwise. A oil filter remval tool may be needed
The oil filter on a 2003 Dodge Dakota is located on the bottom, right side of the engine. A special filter wrench is needed to properly grip and remove the filter.
is there a special tool needed to remove the oil filter on 1990 buick skylark 4 cylinder front wheel drive?
24 mm24 mm
I have always used a variable strap wrench for oil filters. This way you can do many with one cheap tool.
It's under the air filter assembly. Remove the air filter compartment and the fuel filter will be underneath. It's bolted to the sidewall with a bracket. Remove the in and out fuel lines to the filter, then unbolt from the sidewall. Reverse the process with the new filter then replace the air filter compartment. Basic tools are only needed (i.e., sockets, adjustable wrench, screwdriver, etc.) I did mine and it took about an hour, was not that difficult.
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
The oil filter is locate underneath the motor, beneath a plastic shield that covers the entire bottom of the engine. You must first remove all 10mm bolts to remove the shield then use a special wrench to remove the plastic oil filter housing. Do not overtighten the housing or drain plug. I believe 5.8 quarts of oil is needed.
You have to remove the gas tank because the filter is inside the. This is NOT an easy job. I recommend you pay someone to do it right. Cost around $400.
The Oil Filter on this car is what is called a "clip-in" filter the way you remove it is to simply have the correct sized wrench, and remove the Cap and the filter should come with it.
The fuel filter is located in the gas tank. Remove the fuel line. Next, remove the fuel filter retaining plate. Last, remove the fuel filter and replace with a new fuel filter.
if it is a diesel engine you remove the filter cap located at the top near the front of the engine. make sure to replace the o-rings and read the directions provided with the new filter as one of the o-rings has a bevel on it. if it is a gasoline engine you need a special tool to remove the fuel lines from the filter located on the driver's side frame rail near the driver's door. when installing the new filter make sure the arrows are pointing in the right direction.