Hey can you explain where your up to in the removal process ? You can jack the back of the car up so both wheels are off the ground. Then romve both wheels Then you'll have to back off the rear shoes from the inside of the the hub with a screw driver. Then remove centre bearing nut Remove drum and photo or take off one side and see how it goes back together by looking at the otherside for the right procedure. Re-fit drum and adjust shoes until it is frim to turn under hand and no more. Hope it helps.
You have to remove the brake master cylinder and remove alternator through there.
The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
Turn down the adjustor, and it should slide right off.
What size is the steel brake line tubing on a 1994 Ford Ranger
For a 1994 Ford Thunderbird : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )
Underneath the car.
Lift the car, remove the tire and set it aside, remove the brake shoe/caliper, remove the brake pad and dispose of it. Put in the new brake pad, replace the brake shoe/caliper, put the tire back on the car, and lower the car to the ground.
brakes adjust themselves automatically
Lift the car, remove the tire and set aside, remove the brake shoe/calipers and remove the old pads. Replace the old pads with the new pads, replace the brake shoe/calipers, replace the tire and lower the car.
How do you remove the brake light cover on a ford focus
For the 1994, you have to remove the negative battery cable, then depress the brake and hold it in for 5 seconds to reset the check engine light.