how to remove a starter on 2000 dodge caravan
You have to remove the steering intermediate shaft and remove the starter from the top.
Disconnect the - battery cable Lift and safely secure vehicle Remove wires from starter Remove mounting bolts Drop starter
on my 1990 with 3.0 L, behind starter. remove starter to access unit
Remove negative cable from battery Disconnect positive cable from starter and ignition wire Loosen mounting bolts from starter Remove starter Install new starter in reverse order of removal
It is on the drivers side buried behind the starter. You need to remove the starter and then you have access to it.
I replaced the starter on my 96' Avenger. It is located right beside the oil filter. To remove the starter I had to take off the oil filter and the part connecting the oil filter to the car.
its just below the starter. it might be a bit difficult to remove since you're going to have to remove the starter itself to get to the bolt. good luck.
Disconnec battery Starter is located under car where engine meets tranny, remove the electric connectors Remove starter mounting bolts Install new starter in reverse order of removal
disconnected neg battery cable remove bolt and nut attaching starter to bell housing. turn starter slightly and disconnect wires from starter. remove bolt from intermediate shaft at steering box and position out of the way. then remove starter though fender well. reverse procedure
93 dodge caravan starter changedisconnect battery, then underneath at the front mount disconnect wires if possible, if not, remove after removing starter. three bolts and starter comes out. one bolt is slightly hidden. opposite to install.
It sits behind the starter on the drivers side of the engine. You will have to remove the starter in order to see it.