Disconnect the negative battery cable Remove the drive belts. Remove the Power Steering pump pulley. Remove the alternator. Raise and safely support the vehicle. Remove the splash shields. Remove the power steering pump mounting bolts and position the pump aside, without disconnecting the power steering hoses. Remove the automatic transmission cooler line brackets. Mark the position of the driveshaft on the axle flange and remove the front driveshaft. Remove the wiring harness bracket and the automatic transmission cooler line bracket that is next to the starter. Disconnect the electrical connectors from the starter. Remove the fuel and brake line shield. Remove the starter mounting bolts and remove the starter. Clean the mounting surface flanges. Place the starter motor into position and install the mounting bolts. Tighten the starter mounting bolts to 27-38 ft. lbs. (37-52 Nm). Install the fuel and brake line shield. Connect the starter motor wiring. Install the wiring harness bracket. Connect the driveshaft. Install the transmission cooler line brackets. Install the power steering pump and the splash shields. Lower the vehicle. Install the alternator. Install the power steering pump pulley. Install and tension the drive belts. Connect the negative battery cable.
How to remove ignition switch on a 91 Mazda Navajo
how do remove the brake drum on a 1991 mazda 323
Do not install the shims. Your starter should work fine.
must remove oil filter to get starter out have fun
transmission
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring harness at the top of starter Remove starter mounting bolts Remove starter
there is 3 wires to the starter disconnect them. Then remove the mounting bolts and detach the starter the reverse to installation
Push it back as far as you can then push it up or pull it down until the "nose" of the starter clears and remove the starter, you will have to reverse the way you removed it to re-install it.
Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft
MOST LIKELY YOU WILL NEED A HOIST TO EVEN SEE THE STARTER
Maybe not aligned properly may have to install shims
You'll need to remove the intake manifold. The starter is located underneath it.