Auto Parts and Repairs
Fuel Pumps
Chevy Malibu
Ford Bronco Eddie Bauer

How do you remove and replace a 1991 Mitsubishi Eclipse gas tank?

383940

Top Answer
User Avatar
Wiki User
2015-07-15 19:17:48
2015-07-15 19:17:48

Get a manual if you need pictures and it will tell you how also.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

will a 91 Mitsubishi eclipse body parts fit a 91 ford probe

User Avatar

Need a diagram to set the timing Mitsubishi 1991 pu

User Avatar

Jack up the front of your 1991 Mitsubishi Eclipse. Remove the brake pad assembly. Loosen the brake rotor by tapping on it with a hammer or mallet. Slide the brake rotor off. Reverse the process to install the new brake rotor.

User Avatar

I have a 1991 Eclipse GSX and it wasn't getting spark. I tried everything it turned out to be the ECU. It is mounted in the center console of the car. You have to take off the carpet in order to access it.

User Avatar

Make and year? Mitsubishi Pajero 1991 (last of the square shape)?

User Avatar

Remove the front bumper to remove the radiator

User Avatar

You will have to test the resistance on it to make sure it is within specs.

User Avatar

The ECU is located behind the radio remove radio look in that box back there is the ECU to remove it take out panels on both sides of front console remove radio remove screws holding ecu carefully remove clips and pull ecu out passenger side. You dont need to pull the stereo.

User Avatar

You remove grill to remove and replace the headlights.

User Avatar

On the passenger side of the motor (by where the radiator cap is at) where the upper radiator hose goes to the engine. that is the placement on a 2.0.

User Avatar

It is located behind the center console near the ECM. It is large and gold in color

User Avatar

1991 mitsubishi eclipse 2.0L starts 2 to 3 seconds later shuts off

User Avatar

You can buy a Haynes manual at Autozone. There is wiring diagrams and other trouble shooting things in the book.

User Avatar

Mitsubishi RVR was created in 1991.

User Avatar

How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?

User Avatar

Look on top of the compressor for the low side compressor valve.

User Avatar

Remove rear seat and panel underneath seat. How do I remove rear seat?!?!

User Avatar

First remove the fuel tank then remove the pump assembly locking ring then remove the pump assembly.

User Avatar

Remove the light assy and screw it in from the rear.

User Avatar

You have to remove the oil pan to get at the oil pump.

User Avatar

there is a foam insulator between the contacts in this model over time the foam breaks down causing this condition you need to replace the foam unit it was available from Mitsubishi


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.