answersLogoWhite

0


Best Answer
Copy

You have to remove the door panel by unbolting the handle and then removing the panel which you can pull off if your brave or get a removal tool from an auto store. There is a bunch of little tabs that hold the panel in. Once the panel is removed the lock actuator sits near the rear part of the door, you will have to reach in to get it. It's held on by a rivet that will have to be drilled out to remove the actuator. After you remove the rivet reach into the door, disconnect the wire from the bottom of the actuator then remove the actuator from the rod (there is a piece that comes off the actuator and sticks into the door lock rod). Then to install it is the infamous opposite of removal. Good Luck!

User Avatar

Wiki User

โˆ™ 2015-07-15 21:02:59
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove and replace the door lock actuator in a 1987 Ford Mustang 5.0L?
Write your answer...
Submit

Related Questions

Do you have to remove the seats to replace the console on a 1987 Corvette?

no


How do you replace a fuel pump relay in 1987 ford mustang gt?

look underneath the passanger seat


How do you replace the fuel pump on a 1987 Ford Mustang 5.0 LX?

fuel pump is located inside the gas tank.


How do you remove and replace the heater core on 1987 nissan300zx with air?

To remove and replace the heater core on the 1987 Nissan 300ZX with air, begin by removing the dashboard totally. This means the radio panel and the instrument cluster. Remove all air ducts and access the heater core. Remove the bolts holding the core and replace it with a new core. Then replace the dashboard and instrument panel.


Will 1985 front mustang seats fit into my 1987 mustang?

Yes.


How many quarts of oil are needed after new filter for a 1987 Ford Mustang 4 cylinder?

4 Liters when you replace the filter. Always replace filter when you change the oil.


How do you replace the fuel pump on a 1987 Chevy Camaro?

You must remove the fuel tank.


What is the transmission on a 1987 Mustang?

The 1987 Ford Mustang came with a T-5 five-speed manual or optional automatic transmission.


Do you have to remove the fuel tank to replace the fuel pump on a 1987 ford thunderbird?

Sorry Yes You Do.


How do you replace the oil pan gasket in an 1987 Ford Mustang GT?

undo the motor mounts and loosen the tranny mount lift the engine upwards slowly and carefully. remove pan bolts and old gasket.do revers for install .toque to corret specs.


Does a 1987 mustang take clutch fluid?

no


Will a 1987-1993 Ford Mustang door fit a 1985-1986 mustang?

No, it will not.


Will a 1987 mustang wiring harness work in a 1986 mustang?

it will not work the wires and connectot are different


How do you replace a heater core on a 1987 Cadillac Seville?

I need to know how to replace the heater core in a 1987 cadillac seville. I would like to have step by step instructions on the removal and replacemnet of this part. Where it is located and how to remove it


How do you change the ignition switch in a 1987 Ford Bronco 2?

Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê


How do you replace the service engine bulb in a 1987 Chevy Celebrity?

You have to remove the instrument cluster to service the light bulbs.


How do you replace a radiator on a 1987 Ford F-250?

drain remove fan and shroud undo top and bottom hoses and remove about 4 bolts.


How do you replace the heater core in a 1987 Nissan pickup?

Remove the water from your 1987 Nissan pickup truck cooling system. Remove the water supply hose. Remove the water return hose. Remove the heater core retaining bolts. Reverse the process to install your new heater core.


How do you drain the rear end fluid in 1987 ford mustang?

Uniess it has an aftermarket cover with a drain plug the only way is to remove the cover on the rear of the housing. (can be messy)


How do you fix a 1987 Toyota 4Runner passenger seat that won't slide?

remove the seat replace the wire(s) that engage the locking slider replace the slide bearing IAEFs, replace the seat


How do you repair replace a 1987 Corvette power antenna?

Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.


Will a 1987 mustang top fit a 1991 convertible?

YES!


How much horsepower does a 1987 mustang gt have?

( 210 horsepower from the factory ) for the 1987 Ford Mustang GT with the 302 ( 5.0 liter ) high output . The 8th " character " of the VIN is an " M "


How do you replace the gas tank on a 1987 Ford Ranger Super cab?

REMOVE THE BED OF THE TRUCK. YOU CAN GET TO THE BOLTS TO REMOVE THE TANK. 6 BOLTS AND UNPLUG THE WIREING HARNES.


How do you replace the headlight on a 1987 Cutlass Ciera without disassembling the front end?

Remove the light assy with the mounting screws.