Removing the transmission dip stick will give you more room to work, but it's still a hard place to get to.
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
unplug wire remove 2 7/32 bolts remove sensor
On a 2002 Ford Crown Victoria : Bank 2 is the drivers side of the engine Sensor 2 ( downstream sensor ) would be in the exhaust after the catalytic converter
Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 ford explorer?
On a 2002 Ford E-150 : Bank 1 is the passenger side of the engine ( V6 and V8 engines ) Sensor 1 would be close to the engine BEFORE the exhaust enters the catalytic converter ( upstream sensor )
The 1981 Ford Crown Victoria does not have an Oxygen sensor.
On a 2002 Ford Thunderbird : Bank 1 is the passenger side of the 3.9 liter V8 engine Sensor 1 would be close to the engine BEFORE the exhaust enters the catalytic converter
Is there a fuse I can remove for the ford explorer tire sensor
The 1996 Ford Taurus heated oxygen sensor can be found behind the dashboard on the passenger side of the passenger compartment. The oxygen sensor should be labeled as such.
odometer 2002 ford escord
The 1997 Ford Aerostar oxygen sensor is screwed into the exhaust pipe. It is about even with the rear of the oil pan.