Want this question answered?
Place mower near street with FREE MOWER sign. That is the best way to remove the clutch/drive on this POS mower.
They were be-headed primarily with a radically converted Qualcast lawn mower
clutch for (your model mower) on eBay or other site that sells mower parts
how to install a spring clutch on a murray mower
The safety switch to start the motor on a Ranchking riding mower is located in the ignition. If the clutch needs to be depressed several times before the mower will start, there might be a problem with the adjustment of the clutch.
Your mower has an electric PTO clutch that is worn out. It clutch stops working when it gets hot. Replace the PTO clutch and you should be fine. Expect to pay about $150 for the part.
get a smaller pulley for the engine. as far as clutch I'm not sure
No, it is not necessary to remove it. You can charge it right there on the mower.
first thing take the mower to the dump. secondly, push mower into the dump. third, leave the mower there.
The 2146 does not have an adjustable clutch, some other models do.
on a racing lawn mower it would be good, just rev up your engine and will engage.
Your clutch has to be engaged when you start your mower or at least my craftsman mower does. If it dies when you release the clutch pedal, it is due to the engine shutoff relay which is wired to the electric clutch. There are 2 wires on the lower left side of the mower that run along the inside of the frame to the clutch. These wires run just above the mower deck belts and connect to the top of clutch. They are so close that sometimes they get entangled with the deck belts causing them to be torn loose or rub the insulation off and expose the bare wire (which will cause it to ground out if it comes in contact with metal). You need to find and inspect these two wires all the way from the clutch to the point they come up through a hole in the frame floor that the engine is bolted to.