answersLogoWhite

0


Best Answer

I have a 1999 cr-v. With the distributor cap off you must slightly give the key a turn in the ignition (not trying to start it) just to turn the rotor a little. When the teeth on the rotor face the front end of the car you should be able to see a phillip's head screw on the back side that screws directly into the distributor shaft. Unscrew this and the rotor should slide right off. Be careful not to strip the screw, because you might end up having to take off the entire distributor housing to drill it out.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove distributor rotor on 2000 crv?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

need to remove cd on my honda crv?

how do i remove my cd form my crv honda 2003


Where is the Oil pressure switch 2000 Honda crv?

driver left of the oil filter on a 2000 crv


Crv wiper arm removal?

how do you remove the wiper arms on a 2002 CRV?


Is the 2000 crv an interference engine?

Yes , the 2000 Honda CRV has an interference engine ( according to Gates - they manufacture timing belts etc. )


Honda CR-V distributor cap wiring order?

why my crv distributor has no power from the black stripe w gray 1998 model


How do you replace top dead center sensor on 1997 Honda crv?

It is in the distributor housing. You will have remove the distributor cap held on by 3 phillips screws. You can take off the distributor wires but it probably is not necessary. If you do be sure to mark where they go before you reconnect them. You can remove the air filter cap to give you a little more room to work. Next you will have to remove the side screw that holds the distributor coil in. Disconnect all the wires to the coil then pull it out. The TDC sensor should be inside the distributor housing and will have some wires leading to a harness attached to it.


Is the 2000 crv aninterference motor?

is the 2000crv have a interference


How do you remove a stereo from a 1997 Honda CR-V?

how can i remove stereo from honda crv 1997?


What is the max load to pull with 2000 CRV?

1,000 pounds maximum.


Honda 2000 crv clicking noise in engine?

Possibly the lifters?!?


Your crv 2000 will not start?

Not enough information: If it won't turn over: it could be corroded battery terminals - a dead battery - a bad starter - a bad ignition switch. If it will turn over but won't start: out of gas - bad fuel pump - clogged fuel filter - clogged fuel injectors. OR - distributor cracked - rotor needs replacing - bad plug wires - spark plugs need replacement. OR - a combination of any of these problems together.


What kind of oil used for Honda crv 2000?

10W-30 is recommended.