Want this question answered?
No. To remove the widow its easiest to remove the outside panel
you take off the nuts and bolts
It varys from each car but I think you have to take off the door panel. Next you locate the bolts and remove from there.
Remove the dppr panel and there are screws on the inside.
The keyless entry module on the 1997 Suburban is under the dash on the driver's side. The driver's side door needs to be open to see it.
You have to remove the inside door panel then you can see the holding assembly
remove door panel, install new window
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
You have to remove the steering wheel and driver airbag to replace this multi function switch....trust me I had to do it.
Go to the following website. It will show how to remove the door panel and the side mirror. kwmuth.com
The rear gate panel is very easy to remove. You will need a panel remover or a paint scrapper or something flat to pull panel off. Also you will need a screw driver to remove a few screws. Be careful not to break or lose any parts. Good luck...
Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.