This question can not be answered in this forum as it is an illegal act. The Federal Government mandates that the emission system on an automobile is Not to be altered or removed from a vehicle and is punishable with a fine or imprisonment.
how to remove a 1966 283 engine from a Nova
Begin by removing the wiring harness. Remove the retaining screws. The emission control will come off. Reverse the process to install your new emission control.
If you lift the hood, remove the air box (disconnecting the inlet air temp and MAF) and look straight down onto the motor you will see the water temp sensor that is the one that controls the cold engine start. The coolant sensor the controls the gauge is inside and you have to remove the engine cowl
It means there is a problem in the emission system are transmission. Need to have engine scaned with a engine scanner. Some parts stores will do that for free.
it controls idling of car engine, without it it will not idle..
Usually a problem in the emission control system - have vehicle scanned to determine the problem
Usually aproblem in the emission control system - have vehicle scanned to determine the problem
Problem with the emission system have vehicle scanned to determine the problem
C.P.S stands for crank position sensor , with is normally located in the oil pan of the 3.1 motor of a Chevy ,olds or Pontiac engine , the c.p.s controls your ideling of your engine =]
I am trying to drain old antifreeze and replace with new and cannot figure out how to remove the radiator plug on my 2001 Chevy impala 3400V6 engine?
Remove oil filler tube cap....then Wiggle and pull straight up.
no The Chevy Celebrity 4 cylinder engine doesn't use a timing belt, it uses a timing gear. To replace the gear it is necessary to remove the camshaft from the engine as it is a press job. To remove the camshaft it is necessary to remove the engine from the car.