answersLogoWhite

0


Best Answer

1) Open the hood.

2) Remove the 4 bolts along the inner edge (10mm).

3) Take off the wheel well trim and take the bolts off there, and

4) Finally take the bolt in between the fender and the door.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove fender in Toyota Camry 95?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where fuel pump fuse located?

95 toyota camry


How much to replace a fan belt in 1995 Toyota Camry?

There is no fan belt in a 95 Camry


How do you remove a fender from a 95 dodge ram1500?

There are seven steps on how to remove a fender from a 95 Dodge Ram 1500. Some of the step-by-step instructions are remove the screws that hold the wheel well to the fender, remove the bolts from the wheel well fender, and then remove the bolts that attach the fender to the rocker panel flange.


Where is the freon recharge port for a 95 Toyota Camry?

The Freon recharge port for a 95 Toyota Camry is located near the air conditioning compressor. It is near the fire wall, and has a black cap with an L marked on it.


Front engine seal 1995 Toyota Camry v6?

any body know were is the front engine seal located 95 Toyota Camry v6


What is the fuel tank size on a 1995 Toyota Camry?

The basic tank for a '95 Camry holds 18.5 Gal/70 L of fuel.


How do you remove a 95 Toyota Camry transmission?

Hi, you don't need to remove the engine with the trans. You just have to dismount the sub-frame and that's all. Please make sure all cables are disconnected and safety is important.


Is a 95 Toyota Camry 2.2 liter a interference engine?

No , the 2.2 liter four cylinder in a 1995 Toyota Camry is NOT an interference engine ( according to the Gates website , they make timing belts etc. )


Why brake fuse keeps blowing on 95 Toyota Camry?

Your brake fuse might continue blowing in the 1995 Toyota Camry because you have a wire that is exposed and shorting out. You might also have an issue with the brake sensors.


What is the fuse box layout for a 1995 Toyota Camry?

There are basically two main fuse blocks for the '95 Camry. One under the dash on the left of the steering wheel and one in the engine compartment near the battery and driver's side fender. Normally there is a diagram on the cover of the the lid. If not, maybe you can figure the layout out from the confusing related link below.


What is a shape of 97toyota Camry knok sensor?

Check this out: http://cgi.ebay.com/ebaymotors/91-94-95-96-97-98-99-Toyota-Camry-Celica-Knock-Sensor_W0QQcmdZViewItemQQhashZitem51914a26aeQQitemZ350329906862QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories


95 Toyota Camry won't start but starter makes clicking sound?

Solenoid or battery *Check the alternator as well. When my Camry did that, the battery and alternator both needed replacement. -andey78