Want this question answered?
wear gloves, bearings all come out. then you have to remove the sensor off the back of it. along with 6 17mm bolts. How do you change the rotors in the front on a 1998 Isuzu Trooper
Between the two front seats where the hand brake and shifter are is usually what is called a centre console
I believe, you have to remove the caliper and bracket. Then remove the axle nut. All the bearings will come off. A very messy project. They are not just knock off rotors like most cars.
On top in front of engine
Minimum disc thickness vented front 24.6mm .Minimum disc thickness rear 16.6mm. min pad thickness front & rear 1mm
The thermostat on a 1998 Isuzu Trooper is located on the front of the motor. It is in the top radiator hose where it connects to the motor. To access the thermostat, the hose needs to be disconnected from the motor.
my 1995 Trooper had same problem it was the crankshaft position sensor located on the middle passenger side of the motor. I will remove the passenger side front tire and it is behind the shock, tight fit but can be done.
Cleaning will not help. The piston is going cocked in the bore. Rebuild or replace.
passenger side of motor, top, in front of fire wall
How to Install Front Brake Pads Check Related links below.
The firing order for a 99 Isuzu Trooper 3.5l is 1, 2, 3, 4, 5, 6. The number one cylinder is on the left side in the front as you are facing the car.
you have two seats in the front, and a bench seat in the back