Want this question answered?
there is no drive shaft it's front wheel drive
Unbolt it at the shackles, and pull it out from the output shaft.
cut it use jb weld to put back together in half
No, the CR-V is designed as a front wheel drive vehicle.
14mm wrench. remove 4 nuts from the front flange and 4 nuts rear flange. Careful with the driveshaft it's aluminum.
Remove the front drive shaft
You have to remove the drive shaft and take to to a machine shop. It has to be pressed off Rob
Get the drive shaft out of WHAT? Front wheel drive vehicles are considerably more difficult to remove than most rear wheel drives unbolt it
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
You can if you remove the rear drive shaft.
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
if leaking out small hole in middle of front driveshaft yoke, check o-ring in cup on output shaft. have to remove extension housing.