0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type of pulley extractor do you use to remove the pulley from the front of the timing belt cover?
uj
How do you remove a wrx power steering pump?
Undo the hoses remove drive belts from pulleys undo pulley bolt and remove pulley no special tool needed should slide off remove bolts at front of pump remove pump
Where is the crank position sensor on 98 firebird?
On front of engine, lower right (facing front of engine) behind harmonic balancer pulley. It is held on by two bolts (must remove balancer pulley to remove) and is the last item on the wiring harness that runs over the front of the engine.
How do you change the serpentine tension pulley on a 1993 Saturn SC1?
The easiest way to access the pulley is to remove the front right wheel and fender liner. The pulley will be right behind the liner.
Where is the oil filter on a Mercedes 2001 CLK320?
the oil filter is located on the front right side of the engine if your looking into the engine from the front. It is the big black plastic cap that you see, you need the special socket tool to remove and install it.
How do you replace the water pump on a 1995 Nissan Maxima?
jack up front of car passanger side remove front passanger tire open hood remove serpentine belt easiest way is use belt tensioner tool locate water pump pulley remove bolts holding pulley on can use vicegrips to keep pulley from turning remove bolts holding pump on reverse process
How do you change front crank seal on a Nissan sentra 1.6?
Lift car on jack stands, remove right wheel for better access,remove any belts, remove pulley bolt, then use a pulley remover to remove pulley, carefully pry out old seal thebn tap in new seal with mallet or plastic hammer, if pulley has ridges on it you may have to replace pulley or you might still have leaks. reinstall pulley,bolt, belts and wheel. Good Luck.
How do you remove the crank shaft vibration dampener on a 1998 Chrysler Sebring convertible?
After removing the right front tire and fender liner, you remove the serpentine belt. You then remove the crank bolt and use a puller to remove the pulley.After removing the right front tire and fender liner, you remove the serpentine belt. You then remove the crank bolt and use a puller to remove the pulley.
In which direction do you turn the nut on the fan to remove it from the pulley on a 99 S-10?
Looking at the fan from the front you would turn it counter clock wise to remove it. You will probably need to hold the pulley from turning also.
How do you replace the idler pulley on a 97 blazer?
you should be able to put a socket wrench in the front of the idler pulley. Push away from the tension of the belt, then remove the belt. MAKE SURE you remember how the belt came off. Loosen the bolts on the pulley, then remove. Install new pulley, then put the belt back on.
How do you change front crank seal on 2002 F-150 4.2L engine?
Remove serpentine belt. Remove damper pulley with puller. Remove oil seal.
Where is the Crank sensor on a Fiat seicento?
Remove drivers side front wheel. Remove inner plastic wheel arch/guard. The crankshaft pulley is now visible To the right hand-side of the pulley is the crankshaft sensor
