Want this question answered?
Will a tow bar of a vectra b fit a vectra c
vectra b is the earlier engine
Probably not has they never work. On vectra b theres a nut under the handbrake gattor, not sure if its same on vectra c
Its the transmition bottle behind the front bumper nearside just below the headlight. Stupid place to put it as you have to take the bumper off to get to it..
no you have to remove all of it remember to mark the motor shaft and linkage positions
Remove the cover from your third brake light. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out.
they are 2 totally different mdels. Vectra B is from 1995 till 2002, and was upgraded in 1999. Vectra C/Signum is the latest model from 2002 till 2008, and then you of course the newest Vectra D introduced early tis year.
It is very easy to adjust the handbrake on a Vectra C. All you need to do is remove the rear console and release the handbrake. Under the handbrake is a cable with a white end fitting, push down the end fitting onto the plastic locking device. Then pull the lever and it will be adjusted.
there are three on my vectra c 2002 1 is in the engine bay on the left and 1 in the passenger side of the dashboard and one in the boot
hi your cam sensor an a petrol vectra b is under the rocker cover the bit where it says ecotec remove this panel and u will c the spark plugs remove all the bolts from the rocker cover and u will have to remove the top half of the timing belt cover to access the cam sensor it is in between the cam pullies.
# Lock the CD changer unit mechanism (if so equipped) prior to removing a malfunctioning CD changer unit. Refer to "LOCKING CD CHANGER UNIT MECHANISM". # Remove upper cluster lid C by firmly grasping and carefully pulling rearward from instrument panel. # Disconnect hazard switch connector. # Remove lower cluster lid C by firmly grasping and carefully pulling rearward from instrument panel.# Remove six screws and remove audio unit and storage bin/CD changer as an assembly. # Disconnect audio unit connectors.CAUTION: Do not pry or forcibly remove heater A/C control bezel from audio unit face plate or audio unit damage could result.# Release two tabs using a screwdriver and carefully remove heater A/C control bezel from audio unit face plate. # Remove brackets from audio unit and remove audio unit.
yea as long as the stud patten is the same which i an sure it is