You have to remove the window handle which sould be held there by a little clip in the back.Also remove armrest (handle), the inside cover is removed by inserting a flat screwdriver in behind it and popping the clips out or just pulling on it should work.
Answer2003 MPV LX - driver door panel removal1)Remove screw at inside door handle (has plastic cover) 2)Remove screw in elec window control (has plastic cover) 3)Pop entry light cover - remove screw about 3 inches in. 4)Remove Philips head plastic screws gently at rear of door. There are 2. 5)Pop panel off (pop-in connectors)
2006 MPV ES - passenger door panel removal
Same as 2003 MPV LX driver door panel above except step 2. There is no screw in the electric window control. Rather there is a screw in the door release latch assembly (behind plastic cover). The rest is the same. However, I would add that you pull it out at the bottom until all the pop-in connectors are free, and then you slide it up.
Remove the door panel.Remove the bolt from the inside of the door that holds the handle on.
Remove the inside door panel from your 1984 Chevy Caprice. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new exterior door handle.
Remove the inside door panel from your 1994 Chevrolet. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
You remove it and replace it...
You will need to remove the inside door panel of your 1988 Chevrolet Blazer S 10. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
You will need to remove the inside door panel of your 1993 Chevrolet Blazer. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
To install an exterior door handle on a Cherokee Jeep, first remove the window crank handle and the three screws in the inner door trim panel. Second, remove the inner door panel from the door using a trim stick and take off the vapor barrier inside the door. Third, remove the nut on the rear of the door handle, position the exterior door handle, and secure in place.
There are 2 screws on the inside of the door under the door seal, remove and slide the door handle off.
To replace the exterior mirror on a 1996 Beretta, find a small plate on the inside of your door. Remove the screws and install the new mirror.
You have to remove the door panel...not easy, but do-able. Once that is off you can remove the door handle and replace it.
Remove inside trim panel (incl. around the window) With a light you'll see 2 12mm nut at the back of the door handle There a small metal clip that hold the rod to the handle