0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Malibu maxx rear wiper arm removal?
# Raise the rear wiper arm finish cap to expose the wiper arm nut. # Remove the rear wiper arm nut (1). # Lift the rear wiper arm assembly (2) away from the rear window and remove the wiper arm from the pivot shaft. The cap tilts up toward the arm
How do you change the rear swing arm on your 1997 300ex?
remove upper bolt shock remove swing arm nut, remove rear brake master cylinder, remove chain
How do you replace the radiator in a Mazda Protege 2000?
Drain the water from your Mazda Protege radiator. Remove the hoses from your radiator. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
How serious is nearside rear suspension arm?
Very, it's holding up/on your back wheel
How do you replace the rear windshield wiper motor on a 2003 ford escape?
Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.
How do you replace the Rear Wiper Motor on a 2003 Ford Escape?
Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.
How can you remove a 2005 Explorer rear wiper arm?
You can remove the 2005 Ford Explorer rear wiper arm by removing the retaining clip. The retaining clip is just below the wiper arm connection.
How do you adjust the rear camber on a metro geo?
The factory service manual states that rear camber is not adjustable; only the rear toe is adjustable via the control rods. However, worn rear suspension parts can throw off the camber, including (but not limited to) worn suspension arm bushings (also called a "control arm"; the "control rod" is a separate part). Worn knuckle-to-suspension-arm bushings can also cause camber misalignment, as well as loose struts not fastened properly to the knuckle.
Why does your 2002 Nissan Pathfiner wobble when you try to accelerate after releasing the gas pedal?
The rear suspension Trailing Arm bushings are likely worn out and/or the rear shocks are in need of replacement. There is an upper and a lower trailing arm on both sides of the vehicle in the rear suspension. As a test, grab a firm hold on the lower trailing arm and try to twist it. If your able to move it even a little, the bushings are shot.
What is the function of torque arms in a heavy duty suspension system?
A torque arm retains rear axle alignment
Will a 1974 beetle transaxle fit a 1962 beetle?
Not without a huge amount of work. Until 1968 VW used swing arm rear suspension. In 1969 they changed to Independent Rear Suspension, with CV joints.
Where are the sensors for the air suspension compressor on a 2002 GMC Envoy?
if the unit has 4 wheel air suspension then the frt sensors are located on the lower frt control arm and on the rear control arms in the rear if it only has rear air suspension the sensor is located on the rear axle on the drivers side and is attached on the frame it is a very simple level sensor
