How do you remove slave cylinder from rover 75?

To bleed the clutch of a Rover 75, first remove the interior panels on the steering column. Second, remove the master cylinder and use a syringe to inject the fluid into the system and repeat 4 times to bleed the clutch.

THis ain't no question

If no signs of leakage at slave operating cylinder,then check clutch master cylinder for leakage,and look at clutch pedal and see if you see any clutch fliud as rod comes thru firewall.follow all lines.

A cigarette lighter on a Rover 75 is held on using prongs on the side of the lighter. To remove it pull the prongs inside the lighter and pull is off. Be sure to remove the wiring from the rear.

Bleed the furthest from the master cylinder 1st then the rest in order of distance from the master cylinder.

You have to remove the starter motor to view the sensor position Depends on which engine is fitted 4 cylinder 1.8 petrol is at the front of the engine at the flywheel end.

To replace the air filter for a Rover 75, first remove the big plastic cover over the engine, then remove the oil filter cap. Then remove the 5 Allen bolts to reveal the air filter. Refer to your owners manual.

remove elec cables on front of starter/m then remove two bolts from face of starter/m then remove

the master cylinder is on top of the clutch pedal, you will need to remove cover above pedals, and you will see the reservoir cap, its not easy to get to or to take off.

How do i time rover 75 v6 engine/

Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180 Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180

in my opinion yes, i got my 75 rover a while back and it still works perfectly

i would check this page, its how u install new speakers in the doors, but before u can do this, u need to remove the pannel, and all this is explained here http://www.mg-rover.org/howdoi/showart.php?ArtID=439 hope this helps u proud owner of a rover 75 :-)

where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working

The height of the 2006 Land-Rover Range-Rover is 6 ft. 3 in. (75 in.).

you can find the sump plug in rover spares department.

The pollen filter on the 75 is under the trim at the back of the engine bay, just bellow the windscreen, You have to remove the wiper arms and trim to gain access.

you have to take to a rover dealer to put out the service light

Carpet is one piece, without resorting to cutting it out you need to remove seats/centre console and anything else thats screwed or bolted through it.

i have a rover 75, 1.8. it has about 26,000 miles on clock. when does my timing belt need changing

Hi just doing my rear discs and it needs a T50 to remove the screw, hope that helps

under the rear seat on the drivers side on a v6 75

Yes, it is situated above the clutch pedal inside the car. You will have to remove the panel above the pedals to access it.

There are extensive guides on the Rover Owners Club forums. Google it!

No need to take it out. You can just unplug it or find and remove the correct fuse. Look for FrenchMike - rover forum - and send the webasto pcb to him for repair. Its simple to remove the pcb.