answersLogoWhite

0


Best Answer

first off, what model? i own a1985 wideglide and just replaced starter with an allballs easy to do disconnect cables, lower rear brake cylinder,undo 2 thru bolts being careful not to separate two halves

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove starter on 1985 harley?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove starter bendix 0n 1985 harley Davidson fxr?

how do i replace the bendix drive in my 85 harley fxrs


How do you change starter solenoid on a Harley Davidson?

Remove the starter. the solenoid is mounted on the starter.


How do you remove starter Harley Davidson Fatboy 1998?

you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.


How do you replace a stator on a 1995 Harley road king What does the stator do?

Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.


How do you remove a starter from a 1985 Chevy 3500?

with a hammer


How do you replace the starter on a 1985 Chevrolet Silverado C20 Pickup?

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter


How do you replace starter on 1998 Harley fat boy?

disconnect the battery, pull the primary cover and remove the jack shaft, You will need a 1/4 Allen socket to get to the starter bolts. remove battery pos cable from starter and remove


How do you remove the starter on 1987 Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


How do you remove a starter on a rev tech motorcycle engine?

REMOVE OUTER PRIMARY COVER. REMOVE JACKSHAFT NUT( THE SMALL NUT ON THE SMALL GEAR TOP REAR) TWO SCREWS(BOLTS) THAT RUN INWARD THRU STARTER BELOW OIL TANK REMOVE STARTER FROM BACK OF INNER PRIMARY. IF YOU BUY A HARLEY DAVIDSON SERVICE MANUAL, THE PROCEDURE SHOULD BE THE SAME AS HARLEY'S. LAKELIZARD


How do you remove a starter from a 1998 Dyna Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


How do you remove a starter out of a 1985 Chevy Blazer?

Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter


Installation instructions for Harley 2003 Road king starter clutch?

tried to remove starter but shaft and gear seem to be stuck in primary case ..... do I need to open up the primary side to remove, starter just spins but does not engage flywheel.