Open up your tailgate. You will see 2 screws that have a funny pattern to them. These are torx head screws.You will need to remove these to remove the tail light cover.once you remove the screws you will need to pull the light housing away from the vehicle as to get i to get to bulb(s). i requires a quarter turn to remove the plug out of back of housing. Go down to your local auto parts store, (I prefer Advance Auto), take a pair of gloves, just because, and they should be able to help you. They, will also let you borrow a small torx screwdriver to remove the screws, and help you replace any light bulbs, if needed. Good luck.
You can remove the dome light, in your 2000 Chevy Tahoe, by inserting a small screwdriver into the locking slot. Gently pry downward with the screwdriver.
hello i need you help me tell me how to remove the cover light from a license plate i have a ford focus se 2002 to put a new light thanks willie
Open the tail gate...you need to remove 2 screws that hold the tail light cover. The cover is also held in place by a couple of snap on fasterners so you need to pull the cover outward to take it off.
You need to refer to the service manual to remove a 2000 Ford expedition XLTS key-less entry system.
There are two screws on the iner side by the tailgate. simply unscrew and remove. Very simple and uncomplicted.
Check fuses and light bulbs
Dust cover on what?
Below and to the left of the steering wheel , by the brake pedal ( remove the panel cover to access the fuses ) according to the owners manual
On a 2000 Ford Expedition ( 4.6 and 5.4 ) The engine oil filler cap is on an extension tube on top of the passenger side engine valve cover . It's near the front of the valve cover
remove right valve cover on cadilac sts
If it is like my 2000 Cirrus, I use the key to pop the cover off, then just remove and replace.
Below and to the left of the steering wheel , by the brake pedal . Remove the panel cover to access the fuses ( according to the owners manual )