0
How do you remove the Harmonic Balancer on a 1994 Ford Tempo GL?
Wiki User
∙ 13y ago
Works best with a air impact tool. There is room.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Harmonic balancer 1994 Honda Civic?
need more info on what your question is, is it how to remove?
Do you need a puller to remove the harmonic balancer from a 1994 buick park avenue with a 3.8?
yes
How do you change the harmonic balancer in a 1994 buick lesabre?
I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.
How do you remove distributor cap on 1994 z28 Camero?
its located behind the harmonic balancer, you must have a special tool to remove it. then there are four small screws that remove the cap.
Are the threads of the harmonic balancer left or right on a 1994 Plymonth Voyager?
Right
Why does the harmonic balancer on a 1994 Pontiac Bonneville ssei supercharged keep breaking?
The most common reason for the harmonic balancer breaking on a 1994 Pontiac Bonneville SSEI is the inner and outer mass is breaking the balancer down. This happens because your engine is running rough or too high of RPM's.
How do you take harmonic balancer off 1994 Toyota Camry?
with a balancer puller you will need a balancer installer also a hammer of any kind is never ever needed
How do you remove the crank bolt on a 1994 Honda civic?
Use a harmonic balancer holding tool DenLors 648796 to keep the pulley stationary while loosening the bolt.
Where is crankshaft position sensor located on 1994 olds cutlass sierra?
behind the harmonic balancer
How do you know when your harmonic balancer is going out in your jaguar 1994 xj6?
The harmonic balancer is definitely NOT a lifetime part and can and often delaminates so that it starts squealing on cold start even after 80K miles on some Jaguars
How do you remove harmonic balancer from 1994 F150 it will loosen some but feels like it is tightening instead of loosening?
It could possibly be reverse threaded (right to loosen, left to tighten).
Where is the crank position sensor in a 1995 olds delta 88?
on a 1994 it's behind the harmonic balancer
