mine's a 98, but all the rear lighting is accessed through the trunk by pulling back the upholstery. mine's self explanatory from there, not sure about the 97 though
how do you get to it
How do you replace an 1994 3.1 Oldsmobile Achieva s radiator?
did u ever figure it out?
There is a long bolt on top of the headlight/blinker assembly. Remove this bolt and slide the entire headlight/blinker assembly out just enough that you can see the bulb socket. Twist the socket and it will pop right out.
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
Back by the fuel tank itself, look around and it is easy to get and replace
This could mean that one of your bulbs is blown on that side. Check and replace the blown bulb.
Easier to just jack the car up so that you can get under it look for the blinker bulb assembly twist it should come out if you line up the holes replace and reinsert
Changing brakes is a simple task. Lift the car, remove the wheel, remove the brake shoe, replace the pad, replace the shoe, replace the wheel and lower the car.
The headlight assembly has 3 screws that need removed. After removing the screws, then remove the headlight. The turn signal is located in the side light assembly. The blinker or turn signal assebly will pull forward and come out. After pulling it forward you can unsnap the wire and turn the blinker bulb, loosening it, then remove and replace. Be careful replacing the blinker assembly. There is a small part that "snaps" together when it is installed properly. If you do not install properly it will be O.K. but will not be lined up correctly.
2.3L quad 4 is located under the exhaust manifold passenger side. To replace you have to remove the exhaust manifold.
Gene Snitsky went from the WWE, to ECW to RAW to Total NonstopAction Wrestling to doing Walking Dead horror films.