Want this question answered?
You have to remove the center of the axle plate and the axle to remove the brake hub.
Can you show me pictures on a dodge neon 1998 on how to remove and replace a front axle.
remove wheel, disconnect tie rod end, separate lower ball joint from control arm, remove axle nut, slide hub off axle, pull axle from transaxle housing
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Either remove the trans, or remove the front axle on a 4x4.Either remove the trans, or remove the front axle on a 4x4.
A stock half-ton 1977 Dodge Power Wagon should have an NP203 transfer case and a Spicer model 44 front axle. The NP203 is a full-time transfer case with a locking differential in it to allow for a selection between "four-wheel drive" and "all-wheel drive". In other words it would send equal power to the front and rear axles, or divide power between the two axles based on driving conditions. The Spicer 44 front axle is not suppose to have manual locking hubs on it due to the fact that the NP203 transfer case is always sending power to the front axle.
The axle nut for the 1982 Dodge Rampage is the size ofÊ2-9/16. You need to know the exact size in order to get a socket to remove the nut.Ê
You will have to remove the front axle assembly to have enough clearance to remove the oil pan in vehicle.You will have to remove the front axle assembly to have enough clearance to remove the oil pan in vehicle.
The front axle itself does not need to be removed.
like you do in any other vehicle
32mm
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.