To remove the bottom part of the rear seat, lift up on the front of the seat and it will pop out of the latches. To remove the upper part of the back seat you have to remove the 15mm bolts and nuts securing the bottom brackets of the seat. There are two bolts, one on each side of the back bottom. and two nuts securing the seat belts and brackets holding the seat back. The next part is how I found it to be the easiest to get the top loose. lay down in the trunk on your back, grab the bottom of the seat back and while lifting use your elbows to push the top of the seat into the passenger compartment slightly. The top hooks will release and the seat will fall into the passenger compartment. An assistant really helps at this point.
No, the tank has to be removed.
The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
remove back seat then pull out and remove from mounting tray then that's it
The 2004 Dodge Intrepid cooling fan relay switch can be found on the back of the cooling fan motor. The cooling fan relay switch is attached to the fan motor with two retaining screws.
No, a Stratus engine sits transverse, while the Intrepid sits front to back.
The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.
Remove the complete dashboard. This is NOT an easy thing to do! It is back there in the center behind the radio and passenger airbag.
I just got my 2003 Intrepid back from the shop. Exact symptoms - bad oil sending unit.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
A Dodge Intrepid does not have a reset switch. The fuel system is computer controlled.
It would be possible to cause an oil leak while replacing the water pump.
First you must remove the dash plate that is held on by clips. So you must pull on it to get it off. Then there is four screws in the front and a ground bolt in the back. And you must remove the wire harneses and antena cable.
You have to remove the back seat.Remove lower seat coushin. it pulls up then outRemove back part of the coushin 2 bolts in each lower cornerremove retaining clips the hold package tray in place and remove package trayremove the speakersEasy as that :)
You can not disable the factory alarm. It is built in as part of the computers. If it is a aftermarket alarm you should be able to remove it and put the car back stock.
I believe they are welded in. Has to be cut out and the new one welded back in.
replace the seat belt
towerds the back i think maby just take it in
It's on the back of the engine by the transmission. You need to lift the car and go under the car. Right on the back of the engine you will see it. It's kinda of hard to get it out. there is about 4 screws you will need to remove.
First take off the caliperTake off the rotorBack off the rear drum brake adjusterTake the dust cap off of the hubRemove the cotter pin and retaining nut,and the hub assembly will slide off.
front 6 1/2'' back 6x9 infiniti tweetwers 1''
I would use 'Loctite Auto Mirror Adhesive' .
It's on the passenger side cylinder head in the back.
There are three. One on the left, one on the right, and one on the back of the transmission.
Remove the bolts.