remove glove box look at motor area unplug wires to blower motor, remove cover over motor, 5 screws to remove then take out motor and fan assm.
The fusebox which controls the blower motor is under the hood up by the firewall.
should be on the blower itself if not there under the hood
Under the glove box and air bag. Remove the airbag fuse and disconnect the battery before attempting to remove the blower motor.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
blower motor for 1998 gmc sierra 4x4 is located on the passsenger side,under the dash, you will need to remove the glove compartment door for easier accessand to remove blower motor cover.
On the passenger side, bend under the dach, disconnect the coupler, remove the screw of the small hexgonal part and remove the blower motor resistor!
its under your fuse panel on the fire wall there is to nuts to remove
right beside the blower there is a plug ..unplug it and remove the two screws ...pull out your resister
A 1998 Cadillac Deville does not have a blower relay. The system has a fuse and a controller to feed power to the blower motor.
The blower motor resistor is located under the front dash on the passenger side of the truck. It is a fairly simple job to replace...maybe 15 minutes. The blower motor resistor is located under the front dash on the passenger side of the truck. It is a fairly simple job to replace...maybe 15 minutes.
Warning:Always disable the airbag system before working in the vacinity of the impact sensors,steering column or instrument panel * Remove the lower right dash insulator panel below the glove box for access to the blower motor * Disconnect the electrical connector from the blower motor and remove the three screws from the blower motor housing * Pull the motor and fan straight down * To remove the fan from the blower motor use a narrow punch and tap the shaft out of the fan assembly * Install the fan onto the new motor
Should be located at the passenger side firewall Remove air intake hose Remove wiring harness Remove 3-4 small 1/4" screws Twist to remove blower motor