0
How do you remove the bolt on the harmonic balancer of a 1998 Lincoln Town Car?
Wiki User
∙ 15y ago
you unscrew it
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the harmonic balancer on a 1998 Lincoln continental?
the harmonic balancer is the crankshaft pulley approx6 or 7 inch diameter lower pully center of engine the serp belt is driven by power pulley also have a retaining bolt in center
What size socket will BE needED to replace a harmonic balancer on a 1998 Malibu?
15mm
Where is the harmonic balancer on a 1998 Chevy Venture?
It is on the front of the motor, it will be the bottom most pully.
Where is the crankshaft sensor in a 1998 Nissan Altima?
The crankshaft sensor on the 1998 NISSAN ALTIMA is located next to the radiator side of the harmonic balancer
Where is the thermostat located and how do you replace it located on a 1998 Mercury Villager?
Passenger side (front of the motor) in the middle. Just above the water pump. Must remove cover and harmonic balancer to install. Very difficult.
How do you replace gasket seals at the timing chain area oil is leaking out in that area of my 1998 Nissan 200sx-se 16l?
If the oil is leaking from the timing chain cover behind the Harmonic Balancer (main large double pulley the belts run on). After removing the belts you need to remove the Harmonic Balancer using a puller, not to damage it, and then replace the seal in the cover. Inspect the back side of the Harmonic Balancer. The seal only seals to the shoulder of the Harmonic Balancer not the back face. If the shoulder's surface is not smooth replace it or it will leak again. Apply some light grease on the seal and mating surface of the Harmonic Balancer and reinstall. Re-install the belts. If it is leaking around the edges of the cover the sealant may need replacing. Also check the condition of the sealant around the oil pan. Both would require removal/cleaning and re-sealing.
Loosen a harmonic balancer bolt 1998 mustang?
socket and force bar on bolt brace against frame and use starter to loosen
Where is the crank shaft sensor located on a 1998 Pontiac Grand Prix?
It's on the inside of the Harmonic Balancer Pully. It shoud be blue in color
How do replace the timing belt on a 1998 plymouth breeze 2.0 engine?
You can replace the timing belt on a 1998 Plymouth Breeze 2.0 engine using a Harmonic Balancer Puller 5.
Location of the crankshaft sensor on a 1998 Buick Century?
the crankshaft position sensor is located right behind the harmonic balancer mounted on the timing cover
Does a 1998 chevy vortex engine have two timing marks?
There should be advance marks on the harmonic balancer, and timing marks on both timing chain gears.
What is the torque specification for harmonic balancer bolt for a 1998 Dodge Ram 1500 5.9 liter V8?
between 150-180. anywhere in that area is fine
