Want this question answered?
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
== ==
Above the brake pedal pad where the brake actuator rod attaches to the brake pedal bracket.
You will need to remove the retaining ring at the top of your 1979 Chevrolet El Camino ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
The switch is to the left of the instrument panel below the wiper switch. To get to it you must remove the panel surrounding it.
you must pull the axles, remove the bearings and then the hub/brake drum assmbly. comes off as one unit.
There is a lock ring on the inside of the dash where the switch connects. You need to remove this lock ring to remove the switch from the dash.
on the floor usually by the e brake you just step on it to turn it on and off
Remove the side panel on the left front of the interior. The there is one bolt and one nut on the interior that you will remove. There are two nuts on the firewall underneath the brake booster that must be removed. After you remove, in total three nuts and one bolt, you can remove the parking brake assembly. Then just remove the cable. Done.
A malfunctioning brake light and flasher relay switch will cause the brake lights and flashers to stop working. The relay switch can be found below the dashboard on the drivers side of the passenger compartment.
Remove bolts at center hub Slide axle out Remove spanner nut drums should slide off
The 1979 Honda Goldwing horsepower is listed as 79 horsepower.