answersLogoWhite

0


Best Answer
Copy

There are 5 screws that need to be removed, two of which are on the bottom of the bracket, and 3 at the top of the bracket, by the air controls. All 5 screws are easily accessable. Once screws are removed, the bracket pops of, leaving the radio fully exposed.

2015-07-15 21:03:30
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Do you have to remove the trans when you replace an engine on a 1988 Nissan Pulsar?

no u do not


How do you replace air con switch in Nissan Pulsar st?

You need to remove the dash console panel and access from there. Take the top tray out, then unscrew stereo and then the air/heating panel, and take it from there.


How do you remove the gear knob on a Nissan Pulsar?

Twist it. may be hard a first but it should just twist off.


How do you remove the Nissan emblem on the tailgate to access broken latch handle?

2001 nissan how do you remove the nissan emblem to access replace broken handle


How do you remove dash board in Nissan Pulsar?

The Nissan dashboard is held in place by 12 retaining clips. Pry outward on each retaining clip to remove the dashboard. The dashboard will come off into separate pieces.


How do you remove center console of 06 Nissan Pathfinder?

Carefully.


How do you remove a center console of a 2006 Nissan altima?

just remove it and there you go it's out


How do you remove a heater core on a Nissan Altima?

how to replace a heater core on a 2003 Nissan Altima 2.5


How do you replace door hinge bushings on a 1993 Nissan Sentra?

Have to remove the door, then remove pins and bushings


How do you remove the center console from a 1990 Nissan 300zx 2 2?

No, you will die.


How do you replace a water pump for 1996 Infinity Nissan?

remove timing chain


How to remove and replace front brake rotors on 1999 Nissan frontier?

how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up


How do you replace the rear speakers in the 1997 Nissan Altima?

You need to remove the rear seat, then remove the package tray.


How do you replace the taillights in a 2001 Nissan Frontier?

To replace the taillights on a 2001 Nissan front first prop the hatch open. Locate the rear lights plastic housing and remove them to find the bulbs. Replace the bulbs.


How do you remove and replace the front rotors on a Nissan Xterra?

how do you change the rotor in 2000nisan xterra


How do you replace an alternator on a 1994 Nissan truck?

on yours, you will have to remove the bottom shield and work from the bottom of truck.Remove wires from alternator,remove pivotalbolts and remove alternator and replace and tighten belt back.


Replace the center brake light on 98 altima?

The 1998 Nissan center brake light is a sealed unit. The entire brake light unit will need to be replaced. Remove the wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light unit.


Remove battery from Nissan Pulsar 2001?

Open bonnet, use a 10mm spanner, undo Negative terminal, then undo Positive terminal, loosen and remove battery bracket. Reverse procedure to install new battery.


How do you remove the harmonic balancer in a Nissan Maxima?

To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.


How do you remove the center console on a 1993 240 Nissan?

screws dude, take em all out.


How do you replace the brake light on a 1991 Nissan pickup?

Remove the light assy and screw it in from the rear.


How do you replace the low beam headlamp on a 2003 Nissan Altima?

You must remove the front bumper!


How do you replace the taillight bulb on a Nissan Armada?

Remove the taillight assembly to gain access to the bulbs


How do you remove the front rotors on a 95 Nissan PU to replace brake pads?

with a 14mm wrench


How do you replace the ecu on 1998 Nissan Altima?

Disconnect the battery and let set for 10 minutes so you dont set off the air bag. Remove the kick panels on bothe sides of the center console. Remove the bolt/retainer on the connecter and then remove screws on the monting bracket.