Pull straight out, they are friction knobs with flat sides, just like the poles the slide onto.
http://www.justforjeeps.com/tjwrachecokn.html
On top of the switch there is a button, press down. Pull knob off.
Loosen the Jam nut on the bottom of the know CW and then turn the knob CCW..
The fuse box is located under glove compartment. However, if there is desire to access the bulb and fuse on the climate controller, twist and remove the knob and it should be connected at the back.
how to remove the knob of the windshield wiper control there is a slot at the end of the knob close to the dash.Use an angled pliers or bend a wire or paper clip and insert it between the knob and rod towards you to loosen it
On my 2002 X-Type I PUSH the fan knob/rheostat. This cycles the climate control/AC on and off. Hope this helps a bit.
It is a button with a graphic of a rectangle with 3 squiggly vertical lines that cross the bottom line of that rectangle. It is located in the center section of the climate control area, which is below the radio, between the fan speed knob abd the diverter knob. If you have automatic climate control, it is above and to the right of the digital display. If you do not have automatic climte control, it is below and to the right of the temperature knob.
There is a small button on the back of the switch you need to hold down while pulling out the shaft and the attached knob. Then, you can remove the slotted nut freeing the switch.
There is a knob on each door... These, however, do not actually control the mirrors. They roll the windows down so you can reach out and manipulate the mirrors with your hands.
answer is at this link not a compass but is done the same way http://www.lostkjs.com/forum/phpBB2/viewtopic.php?t=33262
There is one bulb for the manual heater control. It is located behind the fan control knob. Remove the knob take a piece of vacuum or windshield washer hose and remove the bulb. Install in reverse order of removal. The bulb is a 194 bulb.
To remove the gear shift knob on the SLK 320, first pry the cover from the gear shift knob. Then, use a screwdriver to remove the screw in the center of the knob. This will then allow the knob to be removed.