Remove the clock from the dash.
Gently insert a small flatblade along the edge of the front case retainer and twist/pop it off. The lens is now easily removed.
pinch the lens side to side and it should come out.
remove the phlip screws in the lens. remove lens. push in on bulb while turning bulb out.
You should be able to pull the lens off to get to the bulb. After you take the bulb out you will see 2 little round pins. Just pull them of and disconnect the wires.
Yes I can --> can you?
Remove the 4 bezel trim phillips screws around trim bezel. Unplug headlamp socket. remove headlamp.install new. replace bezel with 4 screws. yur done.
the telescope, therometer, clock, and objective lens.
If you want to remove the BMW headlight lens simply follow the user manual.
After you take the headlight out, remove the metal clips holding the lens on. The lens has to be pried off because there is silicone there to keep it together
Most binoculars adjust the focus in 1 of 2 ways. End lens adjusting by moving the end of the large lens clock wise or anti clock wise like the old camera lens. Or between the two barrels there will be a thumb screw.
There are two screws on either side of the lens cover remove them and remove the lens cover.Grasp the bulb and push gentle down now turn the opposite direction a clock would turn about 1/8 inchNow lift up and there you have it.Now open the package your new bulb is in and and reverse the process.
When you desire to remove oil from a slide and an immersion lens after using, for example, cedar oil, you would use Xylene to remove the oil. Natural oils can harden on the lens otherwise.
The entire lens of the eye is removed and replaced with a plastic lens.