I think the lens cover has snaps along the top and sides of the lens cover. It also looks as if you would have to loosen the turn signal unit that sits beside each headlight. The headlight lens cover is tucked into a recess along the turn signal unit. It doesn't look as if you would need any tools to remove the old lens covers, but you may need a screwdriver to loosen or remove the turn signal unit next to the lens.
After you take the headlight out, remove the metal clips holding the lens on. The lens has to be pried off because there is silicone there to keep it together
i have dropted the bulb into the headlight and i want to remove the lens to get it out any ideas thanks
Actually.. to take the headlight lens apart, put the Oven on 200, put the headlight assembly in oven for a few minutes at a time, as the headlight assy heats up, the adhesive will loosen up making it easy to remove the lens. For a demonstration, go to Youtube and type in "How to remove headlight lens from assembly"
Remove Front Grille. Remove Electrical Connectors. Remove Bolts (3 ea). Pull out Headlight Assembly.
I assume you mean HEADLIGHT LENS.. .. there are 3 bolts on the back, remove, pull out headlight. Remove clips and broken lens. Replace gasket, lens and put on clips FRONT TO BACK so you don't chip the lens. Reinstall with 3 bolts on back.
Not they are sealed.
Not possible. You have to remove the whole light assembly.
To clean the inside headlight lens on a ford ranger just simply remove the cap and clean.
The head light is a sealed unit. The outer sense is not removable.
you need to remove the bumper to access the 2 10mm bolts of the headlight
first remove indicator lens ,screw on inside of wing.Then remove screw at side of removed lens both upper bolts and then remove nut from underneath headlight.