When I took mine down to replace the 4wd switch I used a 7mm nut driver and started removing the screws that were holding it in. I think there are about 6 or so. One is at the top on the inside of where your speedometer is and is visible there is one down on the right underneath like by the emergency brake and so on. If you look you will see. You can even run your hand around and feel for them. The hardest to get to was under the ashtray back above my console. When all the screws are out wiggle it a little and it will pop off. Be very careful they crack easy!
Wlftkr: One thing I learned, tape the screws to the hole you removed them from and you won't be looking at a couple left overs or wonder why this one is longer, or why it came out so easy but is going in all wrong.
You have to remove the entire dash board to gain access to the heater core.
remove the dash board panel around it and take it out
Under the dash board, exactly in the middel. You need to remove the dash board compleately to get to it.
Its located under the dash, just behind the glove compartment. From what I've read, you have to pretty much remove the entire dash to get to it.
Ihave 2000 grand prix how to remove dash board to remove radio Go to http://www.carstereohelp.com/stereoremovalPontiacGrandPrixSt2.htm
you have to remove the dash a 98 calls from over 6 hours.
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
Drivers side of the dash board next to the door. Also underhood ,drivers side, under black plastic lid.
remove dash from 62 chevy
The blend door is electrically operated and the only way I know of to access it is to remove the dash board assembly.
Under the left side of dash.
do you have 2000 mazda 626 dash board?