Remove ashtray if equipped, push cup holder in slightly and hold down on the plastic lever at the rear left side of ashtray slot while pulling out the cup holder. Least that's how to remove it on a 1999 T&C Limited.
Remove the wing nut from the front turn signal/side marker/park housing mounting stud and remove the housing from the fender. To remove the bulb holder, depress the tab next to the bulb holder, turn the bulb holder counterclockwise andremove it from the housing. Remove the old bulb replace with a new one and install it the reverse procedure of removal. I hope this helps you out.
You will want to make sure you remove the old toothbrush holder and the soapdish. Replace the space with matching tile. You could select a new toothbrush holder and soapdish which stand alone on the vanity countertop.
if there is enough room pull them out of the top of the holder if not support with jack and unbolt and lower to the ground
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
Open the cup holder and remove the two screws on the outside.
Remove original ashtray, remove 4 screws that hold ashtray mounting bracket. This will give access to the 2 screws that hold inner end of cup holder. The cup holder must be pulled all the way out to get to screws. Remove screws, remove 2 screws in front face, cup holder will come right out. Installed updated cup holder in 20 minutes, start to finish!
To replace the 2002 Pontiac Montana battery disconnect both the battery cables from the terminals. Then, remove the screw to the battery holder, located behind the battery. Slide the battery slightly to the front of the vehicle and lift up. Reverse this procedure to put in a new battery.
Pull the cup holder out. Reach back, and at the top rear, center-left, is a tab. Press the tab down and pull out on the cup holder to remove it.
Pay off the balance and close the account. Then reopen a new account with only the primary holder.
You have to remove the panel which goes around the stereo and compartment. You will see four screws which are holding the holder with the stereo and compartment. Remove the screws and take out the holder. You might need to disconnect wire harness and the antenna before you will be able to pull the holder out. The stereo is sitting on 2(4) screws which keep it in the holder.
Take it out