1) Roll window down.
1) Remove 3 Phillips screws, one is where the mirror housing is and 2 are in pull cup
2) If the windows are manual remove the c-clip behind the window crank and remove the crank by pulling off. If you do not have a proper c-clip tool this can be done with a strip of cloth. put the cloth behind the crank against the open end of the clip and rock it back and forth.
3) There are panel clips holding the panel on. Start at the door edge and pry them loose. Use proper panel clip pliers to release the 10 nylon clips holding panel on. Do not try to use a screw driver, knife or other tools as these will break the clips or damage the door panel. The best plier type tool is approx. $30 and the clips are $3 a piece in Canada.
4) Push the door lock down and lift the loose panel over it . Pull the panel forward to get past door handle.
5) If you have electric locks, mirrors etc. you need to release the connections prior to pulling the panel away more the 10 inches or so. It is best to get someone to hold the panel while you undo the eletrical connections as you need two hands to release the clips.
how do you remove the door panel on a 2001 dodge stratus?--2 door
It's all right here: http://www.bodyshopzone.com/archives/trim/door_panels/Dodge/Ram_2002_front_rear/removal_f3.html
To remove the sliding door panel on a Dodge Grand Caravan begin by removing the top plastic panel. Then remove the bottom piece after unscrewing a few screws located on the bottom half of the vans door panel.
If you have an electric side mirror you have to remove the door panel then unplug the electrical connector and then remove the screws that hold the mirror.
no no
remove door panel then remove screws behind mirror. remove door panel then remove screws behind mirror.
Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
# Disconnect negative battery cable # Remove all door trim panel retaining screws and door pull/armrest assemblies if equipped with power mirrors remove the switch knob by pulling it straight back and remove the switch retaining nut # Remove the window crank insert a putty knife between the trim panel and the door and disengage the retaining clips.Work around the outer edge until the panel is free
Using a screw driver, remove all of the screws and the clips from the panel of the car. Pull the panel away gently, remove any wire connectors, and then pull the panel off the door.
You will have to remove the entire door panel to get at the screws that hold the handle assembly to the panel.
There are 10 Phillips screws holding the door panel on. First you would need to remove those. Then you can remove the door panel from the door. On the backside of the door panel you would need to remove the plugs from the backside of the switches. Then you can remove the screws that hold the switch into place on the door panel.
You have to remove all of the Phillips screws,the door handle and the master power window switches. Then tug up on the door panel and it will life right off.