Take off the corner panel- it is connected with tabs so it just pops off. Easy.
Now, the trick is to get the piece with the window/lock buttons off first- this is on by clips- you'll see two little slots to stick a screwdriver in and pop the piece up. Disconnect the wires- mark them to be sure the window goes back to window and door lock goes back to lock. The nice thing is you can now turn on your radio without that annoying "door open" beep going off- making the job that much more pleasant.
There are 3 screws (require 7mm socket) in that general vicinity that need to be removed. Pop the door handle moulding off, starting from the outboard edge. Pop the manual lock casement off with a screwdriver.
OK- now pull straight up- Before you walk away with it- be sure to disconnect the door light and titter speaker connections.
My truck is a 2002 2500. I would gather these instructions should be pretty close for all newer GMC/Chevy trucks. The trick is knowing what is clipped in and what is screwed in. If it doesn't come apart fairly easily- reevaluate what you are doing- you are probably overlooking something.
how to remove the door panels to re and re the speakesrs on a 2001 navigator ? how to remove the door panels to re and re the speakesrs on a 2001 navigator ?
Removing the door panels from a 2001 Nissan Frontier is very simple. The door panel is held in place by a few screws only. Remove the screws and pull on the panel gently to remove it.
remove a couple screws and carefully lift up and then out with it.
Using a screwdriver, remove the screws and the clips from the cars door panel. Pull the panel away from the frame, remove the wiring connections, and the panel will come free.
You have to remove the door panels first and then bend the prongs back and they will come out of the door panel. You cannot remove the speakers until the door panel has been removed.
you must remove two screws that hold panel in place. one is behind lever that opens door ,the other you have to remove red door light lense on bottom of panel to get to,afterwards just slide up.
Use the right sized screwdriver, remove the screws and panels from the door panel and pull the panel away. Remove the wiring connections, and the panel should come free.
remove door panel on a 2002 gmc truck
remove the door panels
There is a clip on the back side of the window crank that you have to take off, then take the door panel off.
You don't need to remove front door panels, the speaker grills come out.
To remove the door panels in a 1987 Ford Ranger, simply crank the cover on the door to pry it open. Then remove the head screws inside and take off the other three screws.